Important Safety Instructions; Things To Consider Before You Connect; Protect Against Power Surges; Instructions At The Beginning Of The User's Guide - RCA L46FHD35 User Manual

Note: If you need
to replace your remote,
call 1-800-338-0376.
A shipping and
handling fee, and the
appropriate sales
tax, will be charged
upon ordering.
Have your Visa,
MasterCard, or Discover
Card ready.
6
Chapter 1 Connections and Setup
1 Connections and Setup

Things to Consider Before You Connect

Protect Against Power Surges

• Connect all devices before you plug any power cords into the wall outlet or power strip.
NEVER plug your TV into an outlet that is controlled by a wall switch.
• Turn off the TV and/or device(s) before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety
Instructions.

Instructions at the beginning of the User's Guide

• Protect devices from overheating.
• Don't block ventilation holes on any of the devices. Arrange the devices so that air can
circulate freely.
• Don't stack devices.
• If you place devices in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air
from it won't flow around other devices.

Position Cables Properly to Avoid Audio Interference

• Insert each cable firmly into the designated jack.
• If you place devices above the TV, route all cables down one side of the back of the TV
instead of straight down the middle.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.

Use Indirect Light

Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft
or indirect lighting.

Check Supplied Parts

Check that the following parts were packed with your product.
REMOTE CONTROL
PART # RC2254701/01
REMOTE CONTROL
PART # RC2254702/01
Graphics contained within this publication are presentation only.
2 AA BATTERIES
CABLE MANAGE-
MENT STRAP
Go to Page 7 to
see the parts list
POWER CORD
for the table stand