Chapter 1: Connections And Setup Things To Consider Before You Connect; Protect Against Power Surges; Protect Devices From Overheating; Position Cables Properly To Avoid Audio Interference - RCA L42WD22 User Manual

Things to Consider Before You Connect

Protect Against Power Surges

• Connect all devices before you plug any of their power cords into the wall outlet or power
strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
• Turn off the TV and/or device(s) before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety
Instructions at the beginning of the User's Guide.

Protect Devices from Overheating

• Don't block ventilation holes on any of the devices. Arrange the devices so that air can
circulate freely.
• Don't stack devices.
• If you place devices in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifi er, place it on the top shelf so the heated air
from it won't fl ow around other devices.

Position Cables Properly to Avoid Audio Interference

• Insert each cable fi rmly into the designated jack.
• If you place devices above the TV, route all cables down the side of the back of the TV
instead of straight down the middle.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.

Use Indirect Light

Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft
or indirect lighting.

Check Supplied Parts

Check that the following parts were packed with your product.
ON•OFF
TV PIP
SAT•AUX DVD
GO BACK
VOL CH
MUTE
INFO
+
MENU CH CTRL
ZOOM- ZOOM+
CLEAR GUIDE
PRESETS
?!+-
DEF
ABC
GHI
MNO
JKL
PQRS WXYZ
TUV
INPUT SUB CH
_,.:=$
2 AA batteries
Remote control
Part # R301F1
Note: If you need to replace your remote, call 1-800-338-0376. A shipping and handling
fee, and the appropriate sales tax, will be charged upon ordering. Have your Visa,
MasterCard, or Discover Card ready.
Chapter 1
Chapter 1: Connections and Setup
Power cord
Graphics contained within this publication are for representation only.
5