ProScan PS52690 User Manual page 53

Set VCR2 • LD Channel
Lets you select the channel that the TV tunes to when you press the
WZR2. LD button. The choices are the same as those listed under Set
W:R 1 Channel, except that the component is the second VCR or
laserdisc player, and the remote button being programmed is
VCR2* LD. For example:
Video 2 Input Choose this if your second VCR or laserdisc player is
connected to the Video 2 jacks on the back of the TV and you want
the TV to tune to Video 2 input when you press the VCR2.LD button.
This is a typical setting for a second VCR or laserdisc player.
Set DSS.CABLE Channel
Lets you select the channel that the TV tunes to when you press the
DSS*CABLE button. Usually, DSS.CABLE can control either a DSS®
receiver connected to the Video 1 input jacks or a cable box
connected to the Antenna A jack.
The choices are the same as those listed under Set VCR 1 Channel,
and include Channel 2 Antenna A and Channel 2 Antenna B. Also, the
component is either a DSS® Receiver or a cable box, and the button
being programmed is DSS°CABLE. For example:
Video 1 Input Choose this if your DSS® Receiver is connected to the
Video 1 jacks on the back of the TV and you want the TV to tune to
Video 1 input when you press the DSS°CABLE button. This is the
typical setting for a DSS® Receiver.
Tile following is an example for a cable box:
Ch 3 Antenna A Choose this if your cable box is connected to the
Antenna A jack on the back of the TV and you want the TV to tune to
channel 3 when you press the DSS.CABLE button. This is a typical
setting for a cable box.
49