ProForm SPORT 1000 User Manual page 14

HOW TO USE A PRESET PROGRAM
n
Insert the key into the console.
See HOW TO TURN ON THE POWER on
page 12.
Select a preset program.
To select a preset pro-
gram, press the
Personal Trainer
Programs button re-
peatedly until one of the
twelve preset program
indicators lights.
When a preset program is selected, the maximum
speed setting of the program will flash in the
Speed display for a few seconds, the maximum in-
cline setting will flash in the Distance/Incline dis-
play, and the program
time will appear in the
Time/Pace display. In
addition, a profile of the
speed settings of the
program will scroll
across the matrix.
m
/oOOOOOOO;//
/oooo,o,o,o///i
Press the Start button to start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings of the program. Hold the handrails
and begin walking.
Each program is divided into 30 one-minute seg-
ments. One speed setting and one incline setting
are programmed for each segment. Note: The
same speed setting and/or incline setting may be
programmed for two or more consecutive seg-
ments.
The speed setting for
the first segment will be
shown in the flashing
Current Segment col-
umn of the matrix. (The
incline settings are not
shown in the matrix.)
The speed settings for
Current Segment
e ® ejj/
the next four segments are shown in the columns
to the right.
When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right will flash and a
series of tones will sound. If the speed and/or in-
cline of the treadmill is about to change, the Speed
display and/or the Distance/Incline display will
flash to alert you. When the first segment ends, a//
speed settings will move one column to the left.
The speed setting for the second segment will then
be shown in the flashing Current Segment column
and the treadmill will automatically adjust to the
speed and incline settings for the second segment.
Note: If all of the indicators in the Current Segment
column are lit after the speed settings have moved
to the left, the speed settings may move downward
so that only the highest indicators appear in the
matrix. If some of the indicators in the Current
Segment column are not lit when the speed set-
tings move to the left again, the speed settings will
move back up.
The program will continue in this way until the
speed setting for the last segment is shown in the
Current Segment column and the last segment
ends. The walking belt will then slow to a stop.
If the speed or incline setting is too high or too low
at any time during the program, you can manually
override the setting by pressing the speed or in-
cline buttons. Every few times a speed button is
pressed, an additional indicator will light or darken
in the Current Segment column. (If any of the
columns to the right of the Current Segment col-
umn have the same number of lit indicators as the
Current Segment column, an additional indicator
may light or darken in those columns as well.)
Note: When the next segment of the program
begins, the treadmill will automatically adjust
to the speed and incline settings for the next
segment.
To stop the program at any time, press the Stop
button. To restart the program, press the Start but-
ton or the speed + button. The walking belt will
begin to move at 1 mph. When the next segment
of the program begins, the treadmill will automati-
cally adjust to the speed and incline settings for the
next segment.
14