ProForm CROSSWALK Excel Owner's Manual page 11

5. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a.
b.
If an extension cord is needed, use only a 14-gauge general-purpose cord of five feet or less in length.
If the walking belt is overtightened, treadmill performance may
decrease and the walking belt may be permanently damaged.
Remove the SAFEKEY and UNPLUG THE POWER CORD.
Using the 3/16" allen wrench, tum both rear roller adjustment
bolts counterclockwise, 1/4 of a turn. When the walking belt is
properly tightened, you should be able to lift each side of the
walking belt 3 to 4 inches off the walking platform. The center of
the walking belt should just touch the walking platform. Be care-
ful to keep the walking belt centered. Plug in the power cord,
insert the SAFEKEY and rtJn the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
Rear Roller
Adjustment Bolts
6. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a.
If the walking belt has shifted to the left, first remove the
SAFEKEY and UNPLUG THE POWER CORD. Using the 3/16"
allen wrench, tum the left rear roller adjustment bolt clockwise,
and the right bolt counterclockwise, 114 of a turn each. Be care-
ful not to overtighten the walking belt. Plug in the power cord,
insertthe SAFEKEY and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
LU
b.
If the walking belt has shifted to the right, first remove the
SAFEKEY and UNPLUG THE POWER CORD. Using the 3/16"
allen wrench, turn the left rear roller adjustment bolt counter-
clockwise, and the right bolt clockwise, 1/4 of a turn each. Be
careful not to overtighten the walking belt. Plug in the power
cord, insert the SAFEKEY and run the treadmill for a few min-
utes. Repeat until the walking belt is centered.
Co
If the walking belt slips during use, first remove the SAFEKEY and
UNPLUG THE POWER CORD. Using the3/16" allen wrench, tum
both rear roller adjustment bolts clockwise, 114 of a tum. When the
walking belt is correctly tightened, you should be able to lift each
side of the walking belt 3 to 4 inches off the walking platform. The
center of the walking belt shouldjust touch the walking platform. Be
careful to keep the walking belt centered. Plug in the power cord,
insert the SAFEKEY and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
7. SYMPTOM: THE NUMBERS IN THE SPEED AND DISTANCE DISPLAYS SEEM VERY HIGH OR LOW
a. Some versions of the console can measure distance and speed in either kilometers or miles. To change the
unit of measurement, hold down the STOP button whileinserting the SAFEKEY in the console. The SPEED
display will show either the letter "M," for "Metric," or the letter "E,, for "English." Press the SPEED Increase
button to select the desired unit of measurement. Remove the SAFEKEY from the console.
STORAGE
Unplug the power cord when the treadmill is not in use.
Remove the bolts, washers and spacer from the lower end of each
upright. Loosen the resistance control on each upright. Carefully lay
the console and upper body arms on the treadmill. Hand tighten the
bolts with the washers and spacers into the treadmill frame. Cover the
treadmill during extended periods of storage.
Remove
11