ProForm 480 Pi User Manual page 6

3. Thread thetwoincluded wiretiesthrough theindicated
holes in thetubeonrightsideoftheUpright ( 11).
Lookintothetuberightupright ( 88)andmakesurethe
Wires(21)havebeen secured tothesideshown. T ighten
thewiretiesandcutofftheexcess fromtheends.
Ties
11
Tie
4. Place theConsole B ase(46)ontheposts ontheUpright.
Make a loopwiththeindicated p lastic tiesandinsert t he
twoWires (21)through theloops. P ull o utonlyenough of
thetwoWires toconnect them totheconnectors inthe
Console Base. P lugtheWiresfully intotheconnectors.
Tighten theloops andcutofftheexcess plastic tie.
WARNING: Donot disconnect o r connecttheWires
whilethe treadmill p owercordis plugged in.
Refer t odrawing 4 b.Thread sixConsole Screws ( 88)into
theUprights ( 11)andtheConsole B ase(46). A fterallsix
Console Screws havebeen started, t ightenthe Screws
until theyaresnug; do notovertightenthe Screws.
4a 46
21
88
46
11
88 88
5. AttachtheStorage Latch(14)totheleftUpright ( 11)with
twoSmall S crews (13).Becarefulnot to overtighten
the LatchScrews.
.... _13
--11
6.
Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.