Table of Contents
Advertisement
5.SYMPTOM: THEWALKING BELTISOFF-CENTER WHEN WALKED ON
a.
li the walking belt has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the allen wrench, turn the
left rear roller adjustment bolt clockwise 1/4 of a turn. Plug in the
power cord, insert.the key and run the treadmill for a few min-
utes. Repeat until the walking belt is cantered.
a
b. If the walkingbelt has shifted to the right, first remove the key
and UNPLUG THE POWER CORD. Using the ellen wrench, tum
the left roar roller adjustment bolt countemlockwise 1/4 of a turn.
Plug in the power cord, insert the key and run the treadmill for a
few minutes. Repeat until the walking belt is centered.
6. SYMPTOM:
"IV RECEPTION IS POOR
a. Antenna--For
the console and television to operate properly, good reception is necessary. If you are using an
antenna, make sure that it is propedy connected and that it is adjusted for optimal reception. (See ANTENNA
CONNECTIONS
on page 17.) In addition, refer to the informationbelow.
b. Ignition---Black spots or hodzontal streaks appear or the picture may flutter or drift. Usually this is caused by
interference from automobile ignition systems, neon lamps, electric ddfts, or other electdc appliances.
Changing the position of the treadmill or other electric appliances may correct the problem.
c. Ghosts--Ghosts are caused by the television signal following two paths--one is the direct path and the
other is reflected from tall buildings, hills, or other objects. Changing the directionor position of the antenna
may improve reception.
d,
Snow--If the "IV is located in the fringe area of a television station where the signal is weak, the picture may
be marred by the appearance of small dots. When the signal is weak, it may be necessary to install an exter-
nal antenna to improve the picture......
e. Radio Frequency interference--This
interference produces moving ripples or diagonal streaks and in some
cases causes loss of contrast in the picture.
f. Picture Size Variation--A
slight picture size variation is normal when you adjustthe CONTRAST or
BRIGHTNESS control.
Note: If one of these symptoms appears when the cable from a CATV company is connected, the symptom may
be caused by the local company broadoasL
7. SYMPTOM:
AN ERROR CODE APPEARS ON THE TV SCREEN
a. Error code "ERROR 2" may appear on the TV if the SPEED increase button or
the PROGRAM START button is pressed and no movement of the walking belt
is detected within seven seconds. Remove the key from the console, wait for ten
seconds, and then reinsert the key. Make sure that you stand on the foot rails of
the treadmill each time you start the walking belt. If the error code appears
again, please call our toll-free HELPLINE. Do not operate the treadmill untilthe
problem is corrected.
ERROR 2:
NO SPEED SIGNAL
CHECK USER MANUAL
Advertisement
Table of Contents
