ProForm 785 TL User Manual page 22

Toturnthe
CCD on or off, press the CCD ON button.
When the CCD is on, the TV screen will appear as
shown below.
1. With CCD. broadcast
ABC ..........
.......... XYZ
No Caption
CCD On
Ch 1
Text Off
2. Without CCD broadcast
caption mode on, text off
When the menu is used, pressing the MENU button will
display a menu that allows selection of channel mem-
ory, the clock, the on timer, the off timer, or picture level
controls. When the MENU button is pressed, the display
will be as shown below.
=' CH MEMORY
ANALOG
CLOCK/TIMER
I> ANALOG
CLOCK/rIMER
"IV Mode Video Mode
3. Push CCD buttons, CCD
Note: In the cases shown
above, the display is for
CCD caption mode on, text
mode off.
Selecting the Data Channel
When the CCD function is on, the data channel is se*
lected by pressing the CCD-1, 2 button. The CCD func-
tion status will be displayed for four seconds.
Using the Text Display Function
The text function can be toggled on or off by pressing
the CCD TEXT button. When the text function is on but
no text data is received, the TV screen will appear as
shown in drawing 2 above. The data channel can be se-
lected while in the text mode, just as when in the cap.
tion mode.
Follow the steps below to connect your VCR (not in-
cluded) to the treadmill. A CATV cable (75 ohm coaxial
cable) is required.
1. Connect one end of the CA'D/cable to the video out-
put jack on the VCR.
2. Plug in the power cord of the VCR. Refer to your
VCR user's manual for proper grounding instructions.
3. Connect the CA'rV cable to the 75 ohm antenna ter-
minal on the treadmill. (See assembly drawing 6 on
page 8 for the location of the terminal.)
To operate the VCR with t.be___ I
TV, make sure that the on/off I
switch located on the front of I
the motor hood is in the =on"
position, and that the power
cord is properly plugged in
(see page 9).
Position
To tum on the TV, press the POWER button on the'IV or
the remote control. Make sure that the TV is on channel 3
or 4. Note: When the treadmill is not in use, you may
want to leave the surge protector plugged in. Each time
the power cord is unplugged, the "IV must go through an
automatic channel resetting routine when the power is
turned on again.