ProForm 785 TL User Manual page 17

2.
Indoor Antenna
Push the end of the 300 ohm to 75 ohm adapter
into the 75 ohm antenna terminal on the treadmill.
(See assembly drawing 6 on page 8 for the loca-
tion of the terminal.)
1. Place the VHF
antenna in the
desired loca-
tion. Connect
the 300 ohm
flat wire to the
screws on the
300 ohm to 75
ohm adapter.
I Screwddve
__ J__l _ VHF300
O.m Flat
300 to 75 Ohm Adapter
• 75 Ohm Coaxial Cable
Refer to the drawing in the lower left comer of this page.
Connect the 75 ohm coaxial cable directly to the 75 ohm
antenna terminal on the treadmill. (See assembly draw-
ing 6 on page 8 for the location of the terminal.)
1. Remove the VHF 300 to 75 ohm adapter or the VHF
cable from the antenna terminal.
2. Connect the
300 to 75 ohm
adapter to the
75 ohm an-
tenna terminal
on the treadmill.
(See assembly
drawing 6 on
page 8 for the
location of the
terminal.)
Outdoor Antenna
VHF Rod
Antenna
300 to 75 Ohm
Adapter
75 Ohm
Terminal
2. Connect the CATV
cable (75 ohm coaxial
cable) to the 75 ohm
antenna terminal on the
treadmill. (See assem-
bly drawing 6 on page 8
for the location of the
terminal.)
75 Ohm CATV Cable
Outdoor antennas are subject to weathering that can
reduce signal quality. Inspect the antenna and lead-in
wiring before connecting the antenna. Any service cen-
ter can explain the various outdoor antennas available.
-S
Combination
__/VHF/UHF Antennas
300 Ohm
Wire
Ohm Adapter
im im
Terminal Coaxial Cable
on Treadmill
Cable
• 300 Ohm Flat Wire
1. Refer to the drawing above. Connect the 300 ohm
fiat wire to the 300 ohm to 75 ohm adapter.
Read the important precautions on pages 2 to 5 of
this manual. Before operat-
ing the TV, make sure that the
on/off switch located on the
front of the motor hood is in
the "on" position, and that the
power cord is properly
plugged in (see page 9).
Ion!
Position
Battery Installation
Before the remote
control can be oper-
ated, two "AAA"
batteries (included)
must be installed.
Slide the battery
cover off the back
of the remote con-
trol. Press two bat-
redes into the re-
mote control. Make
sure that the bat-
teries are turned
as shown.
Reattach the battery cover.
Remote
Control J ....
"'
t i
..... = Battery
"AAA" Batteries Cover
17