Carriage Cable - Oki ML490 Maintenance Manual

3.3.9 Carriage Cable

(1) Remove the printhead (see 3.3.1).
(2) Remove the upper cover (see 3.3.4 (1) – (5)).
(3) Remove the gear case Assy (see 3.3.5).
(4) Remove the space motor (see 3.3.7).
(5) Remove the space rack (3.3.8).
(6) Remove two screws
, and disconnect cable from connector
8
(7) Remove carriage cable
(8) To install, follow the removal steps in the reverse order.
Note on installation:
(1) Take care not to fold the carriage cable
carriage cable
(2) Make sure that the paper end lever
mounting the Control Board.
(3) Make sure that there is not any dust or oil on the connector contact sections A to
D. If it is found, wipe it off by alcohol.
2
2
5
1
42114101 Rev.1
, release the Control Board
1
from fasteners on frame.
7
when assembling into the fasteners.
7
A
0
8
6
C
3
4
9
4
and PCB sheet
2
, , , .
3 4 5 6
during installation. Curve slightly the
7
will not contact the Paper end Sensor
A
A
7
B
D
7
Claw Claw
by lifting clamp
9
when
0
66 /