Oki ML490 Maintenance Manual page 52

(2) When using the continouos paper
1) Set the change lever either to the rear side or the bottom side position. (See Figure
2-13.)
2) Set a sheet of paper either to the push tractor.
3) Press the "FF/LOAD" switch.
4) The LF motor starts its operation to feed the paper up to the print start position.
5) The paper is fed in up to the TOF position (Factory default: 0.85 inches from the top).
Push down the "FF/LOAD" switch.
PE
LF action
When the ""FF/LOAD" switch is pushed down, the LF motor feeds in the sheet about 3
inches. When the LF motor completes the operation and the sheet has not been fed in,
the feeding operating operation becomes, ineffective, thus resulting in the feeding jam.
42114101 Rev.1
Detection of the sheet supplied
Line feed (about 3 inches) until the
detection of the sheet supplied
52 /