Appendix Crs-232C Serial Interface Board (Option); General; Operation Description; Element Description - Oki ML490 Maintenance Manual

Appendix C RS-232C SERIAL INTERFACE BOARD (OPTION)
1.

GENERAL

This section describes the operation of the RS-232C Serial Interface board installed in the Printer
as an option using a start-stop synchronization and serial communications circuit. This serial
interface board is capable of transmitting and receiving simultaneously at speeds up to 19,200
bits per second. Two protocols are available: printer Ready/Busy and X-ON/X-OFF modes.
2.

OPERATION DESCRIPTION

2.1

Element Description

(1) 80C51 with MASK ROM
An eight-bit microprocessor controller that controls the following:
(a.) Serial interface protocol and data transfer through a serial port.
(b.) Message buffer.
(c.) Transmission of parallel data to the printer.
(2) 75189
An RS-232C standard line receiver
(3) 75188
An RS-232C standard line driver.
(4) ROM (No Mount)
A 64Kbit ROM that contains the serial interface control program.
(5) RAM
A 64Kbit static RAM used as a message buffer.
42114101 Rev.1
128 /