Maytag Neptune MDE7500 Use & Care Manual page 14

: SING THE CONTROLS CONT.
Touch the up or down arrow to
set the time to tumble. The
time will increase or decrease
by one minute increments.
Press "Continue" when done.
Touch the appropriate tempera-
ture for the load.
Options Screen -The following options may be added
to customize yourWrinkle Release Cycle:
• "Wrinl(le Prevent"
• "End of Cycle Chime"
• "Remind Chime"
See page 7 for a detailed description of these options.
When the desired selections are made, touch
"Continue" to see the review screen once again.
Freshen Up - the Freshen Up cycle is designed to activate a fabric softener sheet. There is 5 minutes of heated tumble followed by
I0 minutes of tumble in unheated air.
Step
Touch "More Cycles" on the
Home screen.
Step
Add a fabric softener sheet to the
load. Select "Freshen Up".
Step
Review Screen -The default settings for Freshen Up are
15 minutes of tumble using extra low temperature heated
air. You may press Start/Pause to begin Freshen Up or
select any of the areas on the touchscreen to further cus-
tomize the Freshen Up cycle.
Touch
the up or
down
arrow to set
the time to tumble. The time will
increase or decrease by one minute
increments. Press "Continue"
when done.
Touch the appropriate tempera-
ture for the load.
13
Touch the appropriate options then press "Continue".