Maytag Neptune MDE7500 Use & Care Manual page 8

: SING THE CONTROLS CONT.
Step
Review Screen -The Review Screen lists the selected
settings. At this point you may press Start/Pause to
begin drying the load or select "Options" for further
customization of the drying cycle.
Step
Review Screen -The review screen will appear
once again to verify your selections. If they are
correct, press Start/Pause. If they are incorrect,
press the area you would like to change.
Step
Options Screen -The option choices on the left
turn the options on or off. The option choices on
the right show an additional screen with multiple
choices. The following options may be added to cus-
tomize your Sensor Dry cycle:
• "Wrinlde Prevent" - Intermittent tumble in
room temperature air for up to two hours fol-
lowing the dry cycle.
• "Damp Dry Chime" - Chimes when load is
damp.
• "Remind Chime" - Chimes at the end of the
cycle every 5 minutes for up to two hours.
• "End of Cycle Chime" - Chimes once when the
selected dryness level is reached.
When the desired selections are made, touch
"Continue" to see the review screen once again.
Step
Select "Time Dry" from the Home screen. The control defaults to
45 minutes.
Step
Press the up and down arrows to set the appro-
priate number of minutes to dry the load. The time
will increase or decrease in one minute increments.
Press "Continue" when done.
7