Maytag MSB27C2XAB00 User Instructions page 11

Table of Contents

Advertisement

Available languages

Available languages

Apples
Asparagus
Berries
Broccoli
Cantaloupe
Carrots
Citrus Fruit
Grapes
Lettuce
Pears
Spinach
Sensitivity to
Ethylene
High
Med.
Low
High
Med.
Low
Med.
Low
High
High
High
Ethylene
Production
Very High
Very Low
Low
Very Low
High
Very Low
Very Low
Very Low
Very Low
Very High
Very Low
Installing the Produce Preserver (on some models)
CAUTION: IRRITANT
MAY IRRITATE EYES AND SKIN. DANGEROUS
FUMES
FORM WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia,
bleach or acids. Do not get in eyes, on skin or clothing. Do
not breathe dust. Keep out of reach of children.
FIRST AID TREATMENT:
Contains potassium
permanganate.
If swallowed, call a Poison Control Center or
doctor immediately. Do not induce vomiting. If in eyes, rinse
with water for 15 minutes. If on skin, rinse with water.
The Produce Preserver pouches should be installed in their
housing, which is located along an interior side wall of the crisper
or convertible drawer.
NOTE: For best performance,
always use two pouches.
1. Remove the Produce Preserver pouches from their
packaging.
FreshF|ow
TM
produce
preserver
CAUTION
ATTENTION
IRRITANT
IRRITANT
Read cautions
on back,
Life les mises
en garde au dos
2. Lift up on the housing in order to remove it from its mounting
tab along the wall,
3. Open the housing by pulling up and out on the back of the
top of the housing,
4. Place both pouches inside the housing, then snap the
housing back together,
5. Place the housing back on the mounting tab along the wall,
Installing the Status
Indicator (on some models)
The Produce Preserver comes with a status indicator, which
should be activated and installed at the same time the pouch is
installed.
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator,
until the bubble pops to activate the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's rear
bubble has not been popped.
Replacing
the Produce Preserver (on some models)
The disposable pouches should be replaced every 6 months,
when the status indicator has completely changed from white to
red.
To order replacements,
see "Accessories."
1. Remove the old pouches from the Produce Preserver
housing.
2. Remove the old status indicator.
3. Install the new pouches and status indicator using the
instructions
in the previous sections.
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msb27c2xam00Msb27c2xaw00

Table of Contents