Custom Program; Steam Functions - LG DLEX2550 Series Owner's Manual

OW TO USE
CUSTOM PROGRAM
if you have a special combination of settings
that you use frequently, you can save these
settings as a CUSTOM PROGRAM.
TO Save a Custom Program:
_:_ Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
O se the cycle setting buttons to adjust the
settings for that cycle.
O ress the cycle option button(s) for the option
you would like to add. A confirmation message
will be shown in the display.
Press and hold the CUSTOM PROGRAM button
for 3 seconds.
NOTE: You may save only one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
TO Recall a CHstom Program:
O Turn on the dryer.
O Press the CUSTOM PROGRAM button.
O Press the START/PAUSE button to start
the cycle.
STEAM FUNCTIONS
TO Fill the Steam Feeder
Pull out the drawer.
_Lift out the steam feeder.
O Fill the steam feeder just to the filter screen.
f,,,_
Water
ONLY
Steam
Feeder __
_ Place the steam feeder in the drawer; then
push in the drawer until it clicks into place.
iMPORTANT NOTES ABOUT STEAM CYCLES
_ efore using a Steam Cycle, the steam feeder must be filled with water up to the MAX line. If not, the
[qdd will be displayed. Make sure that the steam feeder is filled with water or the drawer is fully closed.
Turn the dryer off then restart the Steam Cycle.
• Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
Before moving the dryer, make sure the steam feeder is empty.
Do not use distilled water; the water level sensor in the steam generator will not work.
Be careful to put the Steam Feeder otherwise water will be overflow.
Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
WARN|NG:
• Do not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive
substances. They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
Do not drink water from the steam feeder. 35