Custom Program; Steam Functions - LG DLEX5780 E Series Owner's Manual

Special Functions. (cont.)
Energy Saver
This option helps to reduce the energy consumption in
the Normal cycle, depending on the load size.
When the Energy Saver option is selected, the cycle begins
with an air dry section and the drying time is increased.
NOTE
The Energy Saver option is turned on by default in the
Normal cycle.
Turn off the Energy Saver option for a faster Normal
cycle which begins with heated drying.
To turn the Energy Saver default off, press and hold
the Wrinkle Care button for three seconds.
ON or OFF appears in the display.

Custom Program

If you have a special combination of settings that you
use frequently, you can save these settings as a custom
program..
* To save a custom program:
1. Turn on the dryer and turn the cycle selector knob to
select the desired cycle.
2. Use the cycle setting buttons to adjust the settings for
that cycle.
3. Press the cycle option button(s) for the option you
would like to add. A confirmation message will be
shown in the display.
4. Press and hold the Custom Program button for 3
seconds.
2
NOTE
You may save only one custom program at a time. 2
Pressing and holding the Custom Program button will
overwrite any previously saved custom program.
1
To recall a custom program:
1
1. Turn on the dryer.
2. Press the Custom Program button.
3. Press the Start/Pause button to start the cycle.

Steam Functions

To fill the steam feeder
1. Open the lid.
MFL67731040_en_170712.indd 39
2. Lift out the steam feeder.
1
3. Fill the steam feeder to the MAX line with water.
Steam
Feeder
4. Place the steam feeder in the square barrel, then
cover the lid.
NOTE
Before using a Steam Cycle, the steam feeder must be filled with
water up to the MAX line. If not, the will be displayed. Make sure
that the steam feeder is filled with water or the drawer is fully
closed. Turn the dryer off then restart the steam cycle.
• Only use water. Do not fill the steam feeder with foreign
substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distilled water; the water level sensor in the steam
generator will not work.
Lid
• Be careful to put the Steam Feeder otherwise water will be
overflow.
• Wipe up any spilled water around the Steam Feeder and the
drawer before starting the dryer.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
wWArNiNg
• Do not fill the steam feeder with liquids such as
gasoline, dry-cleaning solvents, or other flammable
or explosive substances. Failure to follow this
warning can cause serious injury or death.
• Do not drink water from the steam feeder. Failure to
follow this warning can cause serious injury or death.
HOW TO uSE
2
Water
ONLY
2017.7.12 5:18:36 PM
39