Table of Contents
Advertisement
REMOTE
CONTROL
OPERATION
(MODELS
PT-47WX52,
PT-53WX52
AND
PT-56WX52)
Programming
The
Remote
The Universal Remote Control can be programmed to operate many manufacturers'
components,
using the component
function buttons for VCR, DVD, AUX, RCVR, rv, DTV CABLE or DBS. Follow the procedures
for programming
your
Remote Control with or without a code for the component.
Default Modes For Remote Control
TV (Panasonic Only)
Panasonic TV Codes
DTM
DTV (Panasonic Only)
Panasonic DTV Codes
CABLE
CABLE (Preset)
Panasonic CABLE Codes
DBS
DBS (Preset)
Panasonic DBS Codes
,VCR
VCR (Preset)
Panasonic VCR Codes
i DMD/CD
DVD and CD (Preset)
Panasonic DVD Codes
Personal Video Recorders,
Panasonic Personal Video
AUX
Tape and VCR2
Recorders Code
RCVR
Audio Receiver (Preset)
Panasonic RCVR Code
Determine the manufacturer
of the component and look in the table for the code.
Procedure
Confirm that the external component is plugged and operating.
Turn the component off.
ACTION
_)
together, for at least 5 seconds.
Press
O
and
Press appropriate component button on the Remote Control VCR, DVD (CD), AUX (VCR2 or TAPE), RCVR, DTV,
CABLE or DBS.
Enter the 3-digit component code using the Remote Control numeric keypad (0 - 9 buttons).
Press the Remote Control O
to test the component.
If the procedure was successful,
the component will
turn on.
Helpful Hints: Unsuccessful Code
I
I
If the componentdoes not operate with the Remote Control, repeat
the procedure using another code. (Some brands have multipleI
codes).
I
If an incorrect code is entered, or if the procedure takes longer than
30 seconds, the programm ng w fa .
Programming
Without
A Code
This procedure searches all codes and is called the "sequence method."
Confirm that the external component is plugged in and on.
Turn the component off.
ACTION
Press
O
and O
together, for at least 5 seconds.
Press appropriate component button on the Remote Control.
Press MOL • to move forward to the next code. Press • MOL to move backward.
Press the Remote Control e
to test the component. If the procedure was successful, the component
will
turn
on.
Note:
Repeat the above steps until the component code is found. It may take many attempts before the correct code
is found.
ACTION
After the code is found, press
C
to store the code.
25 •
Advertisement
Table of Contents
