Installing A Software Update - Extron electronics 3200s User Manual

Upgrades and Troubleshooting, cont'd

Installing A Software Update

To install a software update, IC U9 or U6 (or both) on the Main Control printed
circuit card is replaced. If the system consists of multiple BMEs, the software IC(s)
in each BME's Main Control PCB may need to be updated. Use the following
procedure to replace the Matrix 6400 Audio Main Control PCB IC(s).
1. Power the system OFF and unplug the AC power cord.
2. Remove the Access Panel. See Page 5-3.
3. Use the PLCC IC puller (Figure 5-3.A) to remove the existing Software IC.
Squeeze the tool to align the hooks with the slots provided in opposite
corners of IC socket U9 or U6. Insert the hooks, squeeze gently and pull the IC
straight out of the socket. Set the IC aside.
4. Note the key (angled corner) of the new Software IC. Orient this to match the key
of the socket and carefully press it in place.
5. Reinstall the Access Panel.
6. Plug in the AC power cord, power the system ON.
7. Verify that the switcher is working properly.
Figure 5-3.A Updating the Software IC on the Main Control Card
5-4 Matrix 3200/6400 Series • Upgrades and Troubleshooting
1 9
J 1
2 0
1
2
PO
W ER
+V
SU PP
-V LI ES
PR
IM AR
Y
RE
DU
ND
AN RS CO
T TX 23 MM
2 UN
IC AT
RX BM IO NS
E
RE
D IA MO
G N TE
O S
TI C SY ST
S ST EM
AT
US
Main Control Card
RED +
MAIN +
J14
J13
RED -
J16
J1
MAIN -
J15
To Diagnostics
LEDs
U9
J8
J5
J4
U6