Extron electronics 3200s User Manual page 4

Quick Start — Matrix 3200/6400 Series, cont'd
3) Review the program's Main screen to see
current configuration and settings.
4) Click System-Config to view the Virtual Map
of the system, then select Configure>Physical
Switchers to view a Physical Configuration of
the system. Examine this screen to ensure that
all BMEs are seen and their type and size is
being accurately depicted.
5) Click Close to return to the Virtual Map
screen.
6) Click Configure>Virtual Switcher to program
desired configuration/changes as necessary.
7) Click OK to save changes and return to the
Virtual Map screen.
8) Click Configure>Room Configuration to
create Rooms, or groups of logically
associated virtual outputs.
9) Click OK to save your changes, then click
Close to return to the Virtual Map screen.
Click Return to Main to return to the Main
Menu, then File>Exit to leave the program.
See Chapter 3 for complete instructions.
Step 9
Cable the switcher for audio input and output.
Each input/output has a 3.5 mm, 5-pole (stereo
models) or 3-pole (mono models) captive screw
connector for audio.
Balanced Input
(high impedance)
Tip
Ring
Sleeve (s)
Sleeve (s)
Tip
Ring
Balanced Output
Tip
Ring
Sleeve (s)
Sleeve (s)
Tip
Ring
Unbalanced Input
(high impedance)
Tip
Sleeve
Tip
Sleeve
Unbalanced Output
Tip
See caution
Sleeve
Tip
See caution
Connect the sleeve to ground (Gnd).
CAUTION
Connecting the sleeve to a negative (-) terminal will
damage the audio output circuits.
Matrix 3200/6400 Series Quick Start
Step 8-3 — Main screen
Step 8-4 — Physical Switchers
Balanced Input
(600 ohms)
Step 8-5 — Virtual Map screen
600 ohms
Tip
Ring
Tip
Ring
600 ohms
Balanced Output
Tip
Ring
Tip
Ring
Mono Input
Step 8-6 — Virtual Switcher
Tip
Ring
Sleeve
Mono Output
Tip
Ring
Sleeve
Step 8-8 — ROOM Mapper