Extron electronics 3200s User Manual page 40

Programmer's Guide, cont'd
Command Response
1VI Jims_Lecture,GrpB
In the 4 examples below, all Ties are read from a 32 x 32 virtual RGBA (red, green, Blue, Audio) system
with Audio/Video breakaway (Grp B). In Examples 1 and 2 below (Video breakaway), only virtual plane 1
(Red) needs to be read, since virtual planes 2 and 3 (Green and Blue) are the same as virtual plane 1.
Examples 3 and 4 below refer to virtual Audio breakaway with virtual plane 4 representing Audio.
Example 1
Explanation: Read Preset 1 Red (plane 1) Ties of Virtual Video Inputs to Virtual Video Outputs
Example 2
1
Explanation: Read Preset
Example 3
Explanation: Read Preset 1 Audio (plane 4) Ties of Virtual Audio Inputs to Virtual Audio Outputs Ø1 through 16.
Example 4
Explanation: Read Preset 1 Audio (plane 4) Ties of Virtual Audio Inputs to Virtual Audio Outputs 17 through 32.
A
DVANCED
V C
IEW OMMANDS
Virtual Output MUTES
Notes:
1. Start output is always Ø1 for Room PRESET, because room has max. of 16 outputs assigned.
2. All "VI" values in responses are 2 numeric characters (i.e. 12 or Ø3) or "na" indicating non-existant virtual
outputs.
3. In "VA" View, any outputs that do not follow show as "- -" in response.
4. SO = "Start-Output" parameter in "Global Preset commands".
5. Rvo - Rvo.... = Set of Virtual Outputs assigned to specified "room" (up to 16 total).
RGB D C
ELAY OMMANDS
Read RGB Delay (for 1 ch.)
Set RGB Delay (for 1 ch.)
Note: Where
D W
IRECT RITE OF
G P C
LOBAL RESETS OMMANDS
Start Write Mode
End Write Mode
Example
Notes:
1. Any non-output switching or invalid command between the Start and End commands will be ignored.
2. If there is no activity for 5 seconds while in write mode, then error E17 occurs.
3. No front panel switching (Actual Switching) is allowed during the Start and End commands.
4. If an End command
4-8 Matrix 3200/6400 Series • Programmer's Guide
Description
Read Preset 1 breakaway information (follow versus breakaway mode)
1*Ø1*Ø1VC
Ø4•64•ØØ•ØØ•ØØ•ØØ•Ø3•Ø1•ØØ•ØØ•ØØ•64•ØØ•Ø1•ØØ•ØØ•Plane 1
1*17*Ø1VC Ø4•64•ØØ•ØØ•ØØ•ØØ•Ø3•Ø1•ØØ•ØØ•ØØ•64•ØØ•Ø1•ØØ•ØØ•Plane 1
Red (plane 1) Ties of Virtual Video Inputs to Virtual Video Outputs 17 through 32.
Ø4•64•ØØ•ØØ•ØØ•ØØ•Ø3•Ø1•ØØ•ØØ•ØØ•64•ØØ•Ø1•ØØ•ØØ•Plane 4
1*Ø1*Ø4VC
virtual input #4 tied to virtual output #17
1*17*Ø4VC
Ø4•64•ØØ•ØØ•ØØ•ØØ•Ø3•Ø1•ØØ•ØØ•ØØ•64•ØØ•Ø1•ØØ•ØØ•Plane 4
virtual input #64 tied to virtual output #18
I S S
NSTRUCTION ET AND IMPLE
ASCII (H -S )
OST WITCHER
VM
ASCII (H -S )
OST WITCHER
D
d *
= delay in 1/2 second increments (i.e. Ø = Ø sec, 1Ø = 5.Ø sec)
ASCII (H -S )
OST WITCHER
P
p
P32
1*1!
1*2&
1*3%
:
:
1*64$
p
p command is issued with no Start command, then error E10 occurs.
no virtual input tied to virtual output #32
I S C
NSTRUCTION ET OMMANDS
RESPONSE (S -H
WITCHER OST
• • • • • • Mut
1 2 64
RESPONSE (S -H
WITCHER OST
Out •Dly
Out •Dly
RESPONSE (S -H
WITCHER OST
Write Preset Ready
End Write Preset
Write Preset 32 Ready
End Write Preset 32
Ø1 through 16.
virtual audio plane
)
)
)