Configuring Your Computer After Removing Or Installing A Pci/Pci Express Card - Dell Inspiron 535 Service Manual

4 PCI Express x1 card slot 5 PCI Express x1 card
8. Replace the card retention bracket (see
9. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
CAUTION: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly
or cause damage to the equipment.
10. Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
11. To complete the installation, see
Configuring Your Computer After Removing or Installing a PCI/PCI Express Card
NOTE: For information on location of external connectors, see the Setup Guide. For information on installing drivers and software for your card, see the
documentation that shipped with the card.
Installed
Sound 1. Enter system setup (see
Card Entering System
2. Go to Onboard Audio
Controller and then
change the setting to
Disabled.
3. Connect the external
audio devices to the
sound card's connectors.
Network 1. Enter system setup (see
Card Entering System
2. Go to Onboard LAN
Controller and then
change the setting to
Disabled.
3. Connect the network
cable to the network
card's connector.
Back to Contents Page
Replacing the Card Retention
Configuring Your Computer After Removing or Installing a PCI/PCI Express
Removed
1. Enter system setup (see
Setup) Entering System Setup)
2. Go to Onboard Audio
Controller and then
change the setting to
Enabled.
3. Connect the external
audio devices to the
computer's back panel
connectors.
1. Enter system setup (see
Setup) Entering System Setup)
2. Go to Onboard LAN
Controller and then
change the setting to
Enabled.
3. Connect the network
cable to the integrated
network connector.
Bracket).
Card.