Moving The Tiller Off The Skid - Craftsman 247.29930 Operator's Manual

4. Snapthe cablehousingclips intothe handleassemblycable
mount.The red clip (reversecable)fits into thetop positionon the
handleassembly,whilethe black clip (forward/clutch cable)feeds
intothe lowerpositionon the handleassembly.See Figure3.
5. Clipthe cables intothe cableguideslocatedon the handle
assemblypanelas seenin Figure4.
MOVING THE TILLER OFF THE SKID
Toroll the tiller off the shippingplatform,putthe wheelsin freewheel,if
they are notalreadyfromthe factory,as follows:
1. Placea sturdyblock underthe transmissionto raiseone wheel
about1"off theground.Removetheclick pin from the wheelhub
and wheelshaft. See Figure5.
2. Slide thewheelfully inward on the wheelshaft. Reinstall t he click
pin throughthe wheelshaftonly (notthroughthe wheelhub).See
Figure5. The wheelshouldnowspinfreely (freewheel) on the
wheelshaft. Repeatwith the otherwheel.
3. Use the handlebar to lift and pull thetiller backwardsto a flat
area.
NOTE:Beforestartingthe engine,the wheelsmustbe placedin the
WHEELDRIVEposition(pins throughwheelhubsand wheelshaft).
This procedureisdescribedinthe operationsectionunderwheeldrive
pins.
F
Red
Reverse
\
Figure4
f
Click Pin
Remove the click pin
from the wheel hub.
(WHEEL DRIVE position)
Slide the wheel fully
inward on the wheel shaft.
Reinstall the click pin.
(Freewheel position)
Figure3
Figure5
J
9