Mitsubishi VS-5075 Owner's Manual page 46

Using the remote control to operate VCRs, cable
boxes, and other equipment
about your remote control
This Projection TV's remote control has four "layers": the TV layer,
the VCR-A layer, the VCR-B layer, and the CABLE layer. Each
layer can be used to operate a different component in your A/V
system. You select the layer you want to use by pressing one of the
"select" buttons across the top of the remote control.
When you first receive your remote control, the TV layer is set up
to operate your Mitsubishi Projection TV, the VCR-A and VCR-B
layers are programmed 1_ooperate Mitsubishi VCRs, and the
CABLE layer is set to operate Mitsubishi audio components.
You can use the following buttons to operate your Projection TV.
• power button
• pause button
• mute control
• super quick view button
• quick view button
• volume control
• input button
• channel control
• enter button
• audio and video controls
• menu button
• cancel button
• display button
• home button
• off-timer button
• number buttons
• PIP controls
• PLAY button
• quick program button
If you have a cable box, a non-Mitsubishi VCR, a Mitsubishi
laserdisc player, or a Mitsub[shi A/V receiver, you can "set-up" the
layers in the remote control to operate these components.
The VCR-A layer can be set to operate a non-Mitsubishi VCR; the
VCR-B layer can be set to operate a VCR, cable box:, or Mitsubishi
laserdisc player; the CABLE layer can be set up to operate a cable
box, laserdisc player, or A/V receiver; and the TV layer can be set
operate an AiV receiver.
setting up the remote control to operate your VCR
111 Turn off your VCR.
Press one of the select buttons across the top of the remote to
choose the layer you want to set up: VCR-A or VCR-B.
@
While holding in the POWER b_ljtton on the remote control,
enter the code number listed in the chart on the following pag
for your brand of VCR. Be sure Lo enter both digits of the code
number. If more than one number is listed, try the first one.
Getting Started