Table of Contents
Advertisement
_>
_>
Important:
Important:
Projection
TV
+ VCR
+ antenna
or cable with a
decoder box (continued)
procedure
(See illustration on the following page.)
0 Connect the incoming
cable to the IN terminal
on the first two-way
splitter.
O Connect
a coaxial cableto
one of the OUT termiasls
on the same
splitter;
connect the other end of this cable to the ANT-A terminal
on the back of the Projection
TV.
O Connect
a second coaxial
cable to the other
OUT terminal
on the
same splitter;
connect the other end of this cable to the IN terminal
on the decoder box.
"
O Connect
the third coaxial cable to the OUT termi sal on the back of
the decoder box; connect the other end of this cab].e to the IN termi-
nal on the second two-way
splitter.
Connect the fourth coaxial cable to one of the Ol.Y]:terminals
on title
second two-way
splitter.
Connect
the other end of this cable to the
ANT-B terminal
on the back of the .Projection
TV.
0 Connect
the fifth coaxial
cable to the other
OUT terminal
on the
same splitter.
Connect the other end of this cable to the VHF-IN ter-
minal
on the back of the VCR.
0 Connect
an RCA pin type video cable to the VIDE()
OUT terminal
on the back of the VCR. Connect
the other end of this cable to the
VIDEO INPUT
terminal
on the back of the Projection
TV.
If you are connecting
a Super VHS (S-VHS) VCR, use a Super Video ca-
ble instead
of an RCA pin type video cable. Connect a Super Video ca-
ble to the S-VIDEO
OUT terminal
on t:he VCR. Connect the other end
of this
cable to the S-VIDEO
INPUT
terminal
on the back of the
Projection
TV.
0 Connect a set of RCA pin type audio cables to the AUDIO OUTPUT
terminals
on the back of the VCR. Use the red cable to connect :_he
right
(R) channel
and the white
cable for connecting
the left (L)
channel.
0 Connect
the other ends of this cable to the AUDIO INPUT
termi-
nals on the back of the Projection
TV.
If your VCR is monaural
(non-stereo),
you will only connect
a single
RCA pin type audio cable. Connect
the cable to the VCR, then connect
the other end to the L (LEFT) audio input
on the back of the Projection
TV.
O Set the VCR to the playback
mode.
Select the desired external input source on the TV (1 or 2) by using the
INPUT buttons on the control panel or remote conlxol.
38
Chapter
2: Connecting
Your Projection TV
Advertisement
Table of Contents
