Table of Contents
Advertisement
_>
Important:
Important:
procedure
(See illustration
on the following page.)
O Connect
the incoming
antenna
to the IN terminal
on the two-way
splitter.
O Connect a coaxial cable to one of the OU:? terminals
on the two-way
splitter;
connect the other end of this cable to the ANT-A terminal
on the back of the television.
Connect
a second coaxial cable to the ol:her OUT terminal
on the
two-way splitter.
Connect the other end of this cable to the VHF-IN
terminal
on the back of the VCR.
Connect
an RCA pin type video cable _o the VIDEO OUT terminal
on the back of the VCR. Connect the other end of this cable to the
VIDEO INPUT
terminal
on the back of the televisio_a.
If you are connecting
a Super VHS (S-VHS)VCR,
use a Super Video ca-
ble instead
of an RCA pin type video cable. Connect a Super Video c_
ble to the S-VIDEO
OUT terminal
on the VCR. Connect
the other end
of this cable to the S-VIDEO
INPUT
terminal
on the back of the
Projection
TV.
O
Connect a set of RCA pin type audio cables to the AUDIO OUTPUT
terminals
on the back of the VCR. Use the red cable to connect the
right
(R) channel
and the white
cable :."or connecting
the left (L)
channel.
O Connect
the other ends of this cable to the AUDIO INPUT
termi-
nals on the back of the Projection
TV.
If your VCR is monaural
(non-stereo),
you will only connect a single
RCA pin type audio cable. Connect the cable to the VCR, then connect
the other end to the L (LEFT) audio input on the back of the Projection
TV.
Set the VCR to the playback
mode.
0 Select the desired external input source on the TV (1 or 2) by using the
INPUT buttons on the front panel or remote control.
Basic Connections
35
Advertisement
Table of Contents
