Changing The Presser Foot; Changing The Needle - Pfaff GrandQuilter Owner's Manual

Operating your GrandQuilter™

Changing the presser foot

Switch off the main switch and unplug the
machine.
1. Raise the presser foot lifter. Loosen the
setscrew (A) with the large screwdriver.
2. Choose the proper foot and insert it from the
bottom.
3. Tighten the setscrew with a large
screwdriver to secure the foot.

Changing the needle

Switch off the main switch and unplug the
machine.
1. Lower the presser foot.
2. Using the large screwdriver, turn the needle
clamp screw counter-clockwise.
3. Loosen the screw and remove the needle
from the needle clamp (B).
4. Insert a new needle into the needle clamp
(B). Make sure that the at side is to the
right. Push the needle as far as it will go and
then thighten the clamp screw (C) rmly.
Note: Use an HL x 5 needle.
To check for a good needle
Put the at side of the needle onto something
at (needle plate, glass etc.).
The gap between the needle and the at surface
should be consistent.
Never use a blunt needle. A damaged needle
can cause permanent snaps or runs in knits, ne
silks and silklike fabrics.
Note: Check the needle frequently for barbed or
blunted points.
16
A
C
B