Troubleshooting Tips - Omron electroTHerapy PM3030 Instruction Manual

If this happens... Possible causes...
The intensity is not Are both pads
felt. Very weak attached to the body?
intensity level.
Have you removed the
transparent film from
the pad?
Are the pads stacked
together or do pads
overlap?
Is the cord properly
connected to the unit?
Is the intensity setting
getting weak?
Are the batteries weak?
TrOUBLeSHOOTING
Try this solution... If this happens...
Attach both to the The skin turns red or
body. the skin feels irritated.
Peel off film on the
adhesive surface of
pads.
Do not stack pads
together or overlap
pads.
Connect cord
correctly into the jack.
Press the ▲
up button.
Replace batteries.
27
Possible causes... Try this solution...
Is the adhesive Wash adhesive
surface of pads dirty surface of pads softly
or dry? with your fingertips
for about 3 seconds
under slow running
water.
Is therapy time Use less than
too long? 15 minutes.
Are the 2 pads Attach 2 of them
attached properly to properly.
the body?
Is the pad surface Replace pad.
worn out?