[Meta Data] Screen (Avchd Mode Only); [Other Functions] Screen - Panasonic AVCCAM AG-AC160P Operating Instructions Manual

[META DATA] screen (AVCHD mode only)

Display
Item
mode
[CARD READ] <CAMERA>
(AVCHD
mode only)
[RECORD] <CAMERA>
(AVCHD
mode only)
[USER CLIP <CAMERA>
NAME] (AVCHD
mode only)
[META DATA <CAMERA>
PROP] (AVCHD
mode only)
[CLIP <CAMERA>
COUNTER RST] (AVCHD
mode only)
[META INIT <CAMERA>
SET] (AVCHD
mode only)

[OTHER FUNCTIONS] screen

Display
Item
mode
[IR REMOTE] <CAMERA>
<PB>
[DV CONTROL] <CAMERA>
(DV mode
only)
Loads the metadata recorded on the memory card into the camera.
[SLOT1] [SLOT2] [NO]
• [NO FILE] is displayed when there is no metadata recorded on the memory
card.
Sets whether to simultaneously record the metadata on a memory card as it is
loaded into the camera.
[ON]: Records simultaneously.
[OFF]: Does not record simultaneously.
Sets [USER CLIP NAME] recording method.
[TYPE1]: The user clip name is the same as the [CLIP NAME] if no
metadata is uploaded or if no uploaded data exists.
[TYPE2]: The user clip name is the same as the [CLIP NAME] if no
combination of data and COUNT value is uploaded, or if no
uploaded data exists.
Displays the metadata recorded in the unit.
[YES] [NO]
Resets the COUNT value to 1.
[YES] [NO]
Initializes the metadata recorded in the unit.
All settings, including the [ON]/[OFF] setting for [RECORD] are cleared.
[YES] [NO]
Sets the operations of the supplied remote control unit.
[ON]: Accepts commands from the remote control.
• Note that if the same type of remote control is used near the
unit, the unit may receive commands from the other remote
control during shooting, for example, and suddenly operate in an
unexpected manner.
[OFF]: Does not accept commands from the remote control.
Specifies the control method when a backup device is connected to the <DV
OUT> terminal for backup recording.
[OFF]: Backup device is not controlled.
[EXT]: Backup device controlled using <START/STOP> button. Note,
however, that recording on the camera is not performed.
[BOTH]: Backup recording performed by the unit and the backup device.
[CHAIN]: When the recording nears the end, recording on the backup device
which is on standby will automatically start.
Description of settings
Description of settings
is the factory default mode.
is the factory default mode.
97