Advertisement
LP Tank Installation
Open front doors of cabinet. Slide out tank support. Set base of tank into tank support hole with tank
collar opening facing to the right as shown. Connect regulator to tank (see page 5 of Use and Care
section). Slide tank back into cabinet.
Problem
Possible
Cause
Corrective
Action
Grill or side burner
will not light
1. The ignition wire came off
the electrical
igniter.
2. The distance
between the
ignition pin and the burner
is greater than 0.1-0.2
inch(side
burner).
3. The ignition wire is broken.
4. The battery has died.
5. The battery is in the wrong
polarity.
6. The electrode
tip does not
produce sparks at the
burner port.
7. No gas supplied.
8. Air shutter opening is too
big.
1. Reconnect
the ignition wire to the
electrical
igniter.
2. Loosen the ignition pin and adjust the
distance,
then fasten it again.
3. Call customer
service for a
replacement
ignition wire.
4. Install a new AA battery.
5. Change the battery polarity.
6. Reinstall
the electrode.
7. Turn on the regulator
valve.
8. Loosen the air shutter and adjust the
opening to a smaller size.
29
Advertisement
