Advertisement
Cut tie wraps holding regulator and side burner valve in place underneath grill head control panel. Be
careful not to cut igniterwires or LED light wire. With the aid of an assistant, lift and place grill head
onto cabinet. Grill head sides go over attachment tabs on cabinet. Make sure that side burner valve
and igniterwires hang outside the cabinet, and that regulator hangs inside cabinet.Attach head to cabinet with 4
screws as shown.
1/4-20 x 5/8" Screw
Qty.4
Burner Box
Cabinet
For each door, insert bottom hinge pin into hole on bottom panel. Push down on top hinge pin to
insert into hole in bottom corner of control panel.Adjust magnets on the bottom panel and front beam
to align the magnets with doors, and then tighten magnet screws.
Left Door --
Right Door
23
Advertisement
