Adjusting Tension Of Cuttinghead Return Spring - Delta ShopMaster MS350 Instruction Manual

4. If an adjustment is necessary, pushin Hock handHe
(D)Fig24,andturncounter-clockwise. Loosen Hockknob
(B)Fig.24,andusea 3mmhexwrench toturnscrew(C)
unfiH bHade i s 90degrees tothetable.Tighten Hockknob
(B).
Fig.24
5. Raise cuttinghead. Pushin andturnHock h andHe counter-clockwise to Hoosen.
6. Movethe cuttinghead a H the wayto theHeft beveH p osition andtightenHock h andHe.
7. Usea combination s quare (A)Fig.25to seeif thebHade i s at 45degrees t o thetabHe.
8. If anadjustment isnecessary, pushin Hock h andHe (D)Fig26,andturncounter-clockwise. Loosen Hockknob (E)Fig.
26,andusea 3mmhexwrench to turnscrew(F)untiH Made is45degrees t o thetabHe. Tighten Hockknob (E). T ighten Hock
handHe.
These positive stopsenable youto rapidlyposition the bladeat the90and45degreebevel a ngleto thetable.
Fig. 25
ADJUSTING TENSION
OF CUTTINGHEAD
RETURN SPRING
The tension of the cuttinghead return spring has been
adjusted at the factory so that the cuttinghead returns to
the up position after a cut has been made. If it becomes
necessary to adjust the spring tension, proceed as
follows:
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Loosen Iockknob (A)Fig. 27 and turn screw (B)
clockwise to increase or counterclockwise to decrease
the spring tension. After the spring tension has been
adjusted, tighten Iockknob (A).
12
Fig. 26
Fig. 27