Side Supports; General Cutting Operations - Delta ShopMaster MS350 Instruction Manual

SIDE SUPPORTS
This machine has two side supports to (1) help stabilize the machine, and (2) to help support long or wide workpieces.
The supports are located on either side of the table. The machine comes with the supports pushed in (Fig. 29D). To
utilize the supports, pull them out to their full length (Fig. 29E).
Fig. 29D Fig. 29E
GENERAL CUTTING OPERATIONS
1. Your machine has the capacity to cut standard 2 x 4's lying flat or on edge, at the 45 degree right and left miter angles
(Figs. 30A and 30B).
2. A standard 2 x 6 can be cut in the 90 degree straight cut-off position in one pass (Fig. 30C).
3. A standard 4 x 4 can be cut with one pass (Fig. 30D).
4. This machine has the capacity to accurately cut crown moldings and other bevel-type cuts (Fig. 30E).
5. Cutting various sizes of plastic pipe is an easy job with this machine (Fig. 30F).
!!
Fig. 30A Fig.30B
Fig. 30C Fig. 30D
14