Range Safety; Stability Device - Kenmore 911.95875 Owner's Manual

30" electric radiant self-cleaning free-standing range
Table of Contents

Advertisement

IMPORTANT SAFETY
INSTRUCTIONS
SAVE
THESE
INSTRUCTIONS
Read
all instructions
before
using
this
appliance.
When
using
gas
or electrical
appliances,
basic
safety
precautions
should
be followed,
including
the following:
Outside
Edge Of
Bracket
To Be
Flush With Left Or
Right Side Of Range
Fig, t
Tools
you
will
need:
• Phillips head screwdriver
,* 1 3/8"open end or adjustable wrench
t,
Remove the bracket from the
prepack located inside the oven.
2. Decide whether the bracket wilt be
installed on the right or left side of
range location.
8. If the bracket side of the range is
adjacent to a cabinet,
place the
bracket against back wall and
cabinet as shown in Fig. t,
If there is no adjacent cabinet,
determine
where the location of
the range side (painted
outside
panel) will be. Place the bracket
with its outside edge at this
location and against back walt.
See Fig, 2
4. Determine whether you will anchor
the bracket to the floor or wall.
Make sure this location is clear of
electrical
wiring or plumbing.
11
Fasten the bracket securely with
the screws provided
Screws are
self-drilling
in wood, plywood,
particle and chip board, and most
metal framing° If attaching
to
masonry, you can buy suitable
screws and anchors at hardware
stores. Use a masonry drill to drill
the required holes
Bracket
Wall
Screw
Must Enter
Plate
Wood Or Metal
Fig. 2
Attachment To Wall
m
1
Using the wrench,
back out the
four leg levelers at least two turns.
See your installation
guide for
more leveling information
before
positioning
range.
Slide the range into place. Be sure
rear leg leveler fully engages the
slot in the bracket. If range cannot
be moved back far enough for
rear leg leveler to enter bracket,
move bracket forward as required
and attach to floor in new location.
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

911.95876911095879

Table of Contents