Hoover WindTunnel Owner's Manual page 9

Install bulb -
Pull
old bulb straight
out of socket.
Push
new bulb straight
into socket until locked in place
Excessive force is not required.
The edge groomers
When to replace
The
edge groomers, located on both
sides of the nozzle, should be replaced
when they appear worn.
I!_I[I]
What to buy
When purchasing edge groomers, ask
for HOOVER part N0. 39511009.
Replace lens - Place onetab (E)on
lens into slot. Press on lens and secure
other tab.
How
to replace
Remove bottom plate
Disconnect cleaner from electrical
outlet.
Lower
handle to lowest position. Turn
cleaner over.
Remove the two screws (F) on botk)m
[)late.
The agitator brush
rolls
When to replace
When agitator brushes are worn, the
agitators should be replaced.
To check condition of brushes, discon-
nect
cleaner from electrical outlet.
Move
edge of a card across bottom
plate while turning agitators. To maintain
cleaning effectiveness, have brush rolls
replaced if brushes do not touch card.
New
brush rolls can be installed at your
nearest Hoover Factory Service Centen
G
Insert
screwdriver between latch (O) and
bottom plate
(H). Pr÷ss
outward on latch.
Pull up on bottom plate and r_move.
Install groomers
Lilt
o11 both old edge groomers and slide
new edge groomers into position as
shown.
Insert
tabs on bottom [)late into slots on
bottom of cleanec
Press front bottom plate down and snap in
place.
Replace screws.
Continued _
9