Hoover WindTunnel Owner's Manual page 6

_A
C
Carpet height
adjustment
The
cleaning of carpet and rugs takes
place at the nozzle (B).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, slide
the nozzle control knob (C) to the desired
setting.
Handle position
For
ease in sliding knob, place handle
in the upright position and tilt cleaner
forward.
Settings
For maximum cleaning performance,
the following _arpet height settings are
_r-omrrlended.
_ Lowest setting: for bare floors and all
types of carpet
Note: If
the cleaner is difficult to push,
slide knob to the next higher setting.
gher settings:
for very
deep
pile carpet where easier pushing effort is
desired, while maintaining good cleaning
per_orrrla nce,
Brush
roll switch
Turn brush roll switch (U)
OFF
to clean
hard surface floors.
Turn brush roll switch ON to clean carpet
and rugs.
The
brush rolls will automatically turn off
when the handle is in the upright
position.
/
Circuit breaker
The
circuit breaker turns off the brush
rolls if there is an obstruction in them.
When tripped, the circuit breaker button
(E) will pop up and the brush roll button
will light up.
The
brush rolls will not turn, but the suc-
tion
motor will continue to run.
To
reset the breaker, turn cleaner
OFF
and unplug it. Clear obstruction. Press
circuit breaker button down.
Turn
cleaner ON and continue cleaning.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle.
This
will lift up the nozzle (front
of cleaner) and will prevent rug from
clinging to cleaner. Continue to lift up
nozzle so that when you have reached
the edge, it is completely off the rug.
Move
cleaner back to start again, lower
nozzle, and use only f_)rward strokes.