Page 1
WindTunnel ™ ™ with V2 Technology ™ TurboPOWER by HOOVER Congratulations on your purchase! Owner’s Manual ENGLISH pp.1-12 ESPAÑOL pág. 15-22 FRANÇAIS p. 23-30 This product was designed for easy assembly (see page 3) www.hoover.com...
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
If you need any assistance: Visit our website at www.hoover.com. Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.
Cleaner Assembly Snap tabs on carry handle (B) into Push switch down to OFF position. Remove cardboard (A) and four holes on handle section. screws from handle section. Discard cardboard, but keep screws for assembly (Figs. 1-7 and 1-8). Slide handle section onto back of handle. Push screws into holes on back of handle (Fig.
2. How to use The assembled cleaner will look like the drawing. Cleaner description 1. Handle 18. Cord hooks: wrap cord around hooks for 2. ON/OFF switch storage. The top hook 3. Tool cover rotates right or left for 4. Dusting brush easy cord release.
Carpet height Handle position Settings adjustment For ease in sliding knob, place handle For maximum cleaning performance, in the upright position and tilt cleaner the following carpet height settings are The cleaning of carpet and rugs takes forward. re c o m m e n d e d . place at the nozzle (B).
Extra reach hose 2-15 2-11 (available at additional cost if not includ- ed with your cleaner) The extra reach hose provides a 20 foot reach to allow easier cleaning of stairs and hard-to-reach high places. To attach hose to your vacuum cleaner, follow the instructions below.
Leading Retailers, Hoover Factory Ser- when dirt reaches the dotted line. If more vice Centers or through The Hoover d i rt than this accumulates, your cleaner will It is imperative that you use only Company on-line at www.hoover.com.
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. Install bulb - Replace lens - Pull old bulb straight Place one tab (E) on out of socket. Push new bulb straight lens into slot.
Agitator brush roll replacement When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088. 3 - 1 5 3. Remove agitator including end plates 2. Unscrew the two Phillips screws and (C) and discard.
• Circuit breaker tripped Hoover Cleaning • Reset circuit breaker as described in Performance Fig. 2-9. This Hoover Cleaning Performance Sys- • Filter bag full tem is for comparing the relative pro- • Change filter bag. gressive performance of Hoover •...
(U.S. only). there are questions concerning this warranty or the availability of warranty Do not send your cleaner to The Hoover service outlets, write or phone the Company in North Canton for service, Consumer Response Center, The Hoover this will only result in delay.
Page 14
HOOVER et sont des marques déposées HOOVER y son marcas registradas HOOVER and are registered trademarks 9-02 U8122-900 Printed in Mexico 56511-B63...