Delete A Program - Hitachi 60FX32B Operating Manual

USING THE VCRPlus+ FUNCTIONS
I
DELETE A PROGRAM
You may occasionally wish to delete a program which has been entered into the remote control for recording.
1. Press the VCR+ button on the remote control.
2. Press the REVIEW button on the remote until the program you wish to delete is displayed.
3. Press the CANCEL button on the remote, then 'CANCELLED' will be shown in the remote control display.
4. Repeat steps 2 and 3 to delete additional programs.
5. Press a remote control mode button ('IV, CABLE, or VCR) to return the remote to normal operation.
NOTE:
1. If the program information displayed on the remote does not match the program you wish to record, the wrong
PlusCode has been entered. Check your TV program guide and repeat the above procedure. If the prograrn infor-
mation is still incorrect, make sure the VCRPlus+ Channel Set Up procedure has been completed. (See page 26.)
2. Some stations may have two VCRPlus+ codes. Enter the code which corresponds to the channel on which you
receive the station. Use the REVIEW function (see page 28) to make sure the information programmed into the
remote matches the program you wish to record.
3. The program guide channel displayed with program information on the remote should match the ('olJmn 2
number (page 27) for the station you wish to record.
4. It will not be possible to use this VCRPlus+ record function if the remote control clock is not set or the remote
has not been programmed for your VCR.
5. Make sure there is a blank tape in your VCR for recording.
6. When the remote is programmed to control your VCR only or it controls your VCR and cable box but function
code 0090 has been enabled (see page 24):
• VCR should be off.
• Remote should be aimed at your VCR.
• At the program Start Time, the remote will power on the VCR, tune the correct VCR channel, and start recording.
• .At the program End Time, the remote will stop recording and power off the VCR.
7. When the remote is programmed to control your VCR and cable box:
• Cable box should be on.
• VCR should be off.
• Remote should be aimed at your VCR and cable box.
• At the program Start Time, the remote will tune the correct cable box channel, power on the VCR. aqd start
recording.
• At the program End Time, the remote will stop recording and power off the VCR.
8. If 'CLASH' is di._;played when entering a VCRPlus+ program, another program is scheduled for re,sording at
that time.
9. If you enter a program recording mode (ONCE, DAILY, or WEEKLY) which is invalid, the message "Err: CODE"
will be displayed. (i.e., you choose DAILY for a program which is on only once a week ',
10. If recording is manually stopped before VCRPlus+ recording End Time, the remote control will remain in record
mode and turn the VCR off at End Time. To prevent this, delete the program using the: delete procedL_re.
29