Vcr Functions - Hitachi 60FX32B Operating Manual

USING THE VCRPlus+ REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs.
system of your VCR. (Refer to page 25.)
You must first program the remote to match the remote
1. Turn ON yourVCR.
2. Aim the remote control at the front of your VCR.
3.
4.
Hold down the VCR button on the remote. After approximately 2 seconds, the message VCR-_ _ will appear in
the remote control display. While still holding down the VCR button, enter the 2 digit preset code that matches
your VCR as shown on page 25. The remote will turn off your VCR when the correct 2 digit presel code is
entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after 5
seconds, try a different 2 digit preset code.
The remote will now control your VCR.
NOTES:
1. I! your VCR cannot be operated after performing
the above procedures, this means that your
VCR's code has not been precoded into the
remote.
2. Ii1 the unlikely event that your VCR cannot be
operated after performing the above procedures,
please consult your VCR operating guide.
3. The remote control will remember the codes you
have programmed in until the batteries are
removed from the remote control. After replac-
ing the batteries repeat the entire programming
procedure as :stated above.
4. The MENU button will act as the VCR MENU
button for HITACHI VCRs.
5. The SLEEP button will act as your VCR '100'
button if required.
6. The ENTER button will act as your VCR ENTER
button if required.
7. II the VCR button is pressed and the remote is
already in VCR mode, the date and day will be
displayed for about 5 seconds. (See page 26 for
Remote Control Clock Set procedures.)
8. II = the remote has not been programmed for a
VCR and the VCR button is pressed the mes-
sage "Err: SETUP" will be displayed.
Q
®
VCR button
This button allows the remote to control your VCR
by setting it to VCR mode.
PRECODED VCR buttons
These buttons transmit the chosen precoded VCR
codes.
®
HITACHI
CLU-43,4VP
EXCLUSIVE "IV buttons
These buttons are for operating the "IV.
22