Hitachi 60FX32B Operating Manual page 24

USING THE VCRPlus+ REMOTE TO CONTROL
CABLE/SATELLITE BOX AND VCR FUNCTIONS
In addition to controlling all the functions on your HITACHI Projection TV, the new VCRPlus+ remote is desi!;ined to
operate different types of VCRs and CA'I'V (Cable TV)/Satellite converters with one touch. The procedures for pro-
grammirg the remote to control your Cable/Satellite box or VCR have been explained on the previous pages. (See
pages 22 and 23.)
However, many Cable/Satellite boxes and VCRs vary in control functions. For example, in order to change channels,
some VCRs require the user to press an ENTER button after pressing the digit keys. Your VCRPlus+ remote control
allows you to program the remote for these varying control functions, based upon your specific needs.
The following procedure allows you to program the VCRPlus+ remote for your specific needs. The table below gives
a description of each special function which can be programmed into the remote.
1. Press the VCRPlus+ button on the remote.
2. Enter the 4 digit FUNCTION CODE for the special function you wish to enable, according to the table below.
3. Press the ONCE_/[FRZ] button on the remote.
4. Repeat steps 1-3 until all special functions you wish to enable have been programmed into the remote.
5. Press the IV button on the remote to return to normal operation.
I NOTE::
If your Cable/Satellite box or VCR does not require these special functions, ,or you do not wi,._h to
enable these functions, it is not necessary to follow these procedures.
FUNCTION CODE
0090
0091
OO92
0093
0O94
OO8O
0081
0082
0083
0084
I FUNCTION DESCRIPTION
User has set the cable brand number but maywish to change the VCR
channel instead of the cable box channel in VCRPlus+ recording.
(See page 29 for details.)
For some VCRs (or Cable boxes), after pressing the digit keys to change the
channel number, the userwill need to press the ENTER keyto confirm the
channel number has been changed. This function enables the remote to automatically
send the ENTER IR code after the channel has been changed.
This function will disable the CH100 function in 0092)
Automaticallysends out the CH100 IR code when a 3 digit channel is entered.
This function will disable ENTER code in 0091)
When a two digit channel is changed, some VCRs (or Cable boxes) mayrequire
,a longer separation time between the two digits. This function makes the separaion
ibetween two digits to be 1 second.
When a two digit channel is changed, some VCRs (or Cable boxes) may require
a shorter separation time between the two digits. This function makes the separation
between two digits to be 0.25 second.
Clear all special function settings.
Clear the 0091 function.
Clear the 0092 function.
'Clear the 0093 function.
Clear the 0094 function.
1
* Special functions 0091,0092, 0093 and 0094 will be cleared if a new VCR brand number is set.
24