Table of Contents
Advertisement
USING THE REMOTE TO CONTROL
VCR FUNCTIONS
Operating the precoded function for your VCR
This remote isdesignedto operate different types ofVCRs. You must first program the remote to match the remote system
in your VCR. (Refer to page 22.)
1. Turn ON yourVCR.
2. Aim the remote control at the front of your VCR.
3,
While holding down the VCR button on the remote, enter the 2 digit preset code that matches your VCR as shown on
page 22. The remote will turn off your VCR when the correct 2 digit preset code is entered. When this occurs,
the remote control is programmed for your VCR.
If the VCR does not turn off after 5 seconds, try a different 2
digit preset code.
4. The remote will now control your VCR.
NOTES:
1. If y.ourVCR cannot be operated after performing
the above procedures, this means that your
VCR's codes have not been precoded into the
remote.
2. In the unlikely event that your VCR cannot be
operated after performing the above procedures,
consult your VCR operating guide.
3. The remote control will remember the codes you
have programmed in until the batteries are re-
moved from the remote control. After replacing
the batteries repeat the entire programming pro-
cedure stated above.
4. If your VCR does not have a power function, the
remote will issue the CHANNEL A
function.
(_VCR
BUTTON
This allows the remote to controlyour VCR by
settingitto VCR mode.
Q
PRECODED VCR BUr]-rONS
These buttons transmit the chosen precoded VCR
codes.
EXCLUSIVE TV BUTTONS
These buttonsare for operatingthe TV.
20
Advertisement
Table of Contents
