Haier GDZ5-1 User Manual page 23

GDZ5-1 manual 10/22/01 11:44 AM Page/_l) \
3oWir÷ Cord Conn÷c ions
green
ground
screw
green
neutral
ground
wire
silver terminal
nut
tighten nut
to these threads
cord
strain relief
mounting bracket
1, Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back of the
dryer upper corner,
2, Install a U.L. approved strain relief into the power cord entry hole
of the mounting bracket. Finger tighten the nut only at this time,
3. Thread a U.L. Approved 30 Amp, Power cord, NEMA 10-30 Type
SRDT, through the strain relief,
4. Attach the power cord neutral (center wire) conductor to the silver
colored center terminal on the terminal block.
Tighten the screw securely.
5. Attach the remaining two power cord outer conductors to the
outer brass colored terminals on the terminal block. Tighten both
screws securely. Warning: Do not make a sharp bend or crimp
wiring/conductor at connections.
6. Reattach the strain relief mounting bracket to the back of the dryer
with two screws. Tighten screws securely,
7, Tighten the screws securing the cord restraint firmly against the
power cord.
8, Tighten the strain relief nut securely so that the strain relief does
not turn.
9, Reinstall the terminal block cover,
22