Goldstar WG8005R Owner's Manual page 16

Installation
9. Attach each Frame Curtain the window sash
using screws (Type C).(See Figure 6)
: DO NOT DRILL A HOLE IN THE
BOTTOM PAN. The unit is designed to operate
with approximately 1/2" of water in bottom pan.
iiiiiiiiilHii/Hi!!iiii ,,'i::ii iJi iiii!L,:i;i ii i i iiiii!!! I
I
[_- Figure S
10. Slide the unit into the cabinet.(See Figure 7)
: For security purpose, reinstall
screws(Type A) at cabinet's sides.
Screw(Type A)
/ Power Cord
/
7
Screw(TypeA) .,_ure
11. Cut the Foam-Strip to the proper length
and insert between the upper window sash
and the lower window sash.
(See Figure 8)
Foam-Strip
Figure 8
12. Attach the Window Locking Bracket with
a Type C screw. (See Figure 9)
13. Attach the front grille to the cabinet by
inserting the tabs on the grille into the tabs
on the front of the cabinet. Push the grille
in until it snaps into place. (See Figure 10)
14. Lift the inlet grille and secure it with a Type
A screw through the front grille.
(See Figure 11 )
15. Window installationof room air conditioner
is now completed.See ELECTRICALDATA
for attachingpowercord to electricaloutlet.
J Window Locking Bracket
Figure 9
Figure10
Figure11
16 Room Air Conditioner