Replacing Belts - Hoover innovation U4231 Owner's Manual

The belts
The belts on your HOOVER
cleaner cause the agitator to
rotate and are important for the
effective operation of the cleaner.
The belts are located under the
bottom plate of the cleaner and
should be checked from time to
time to be sure they are in good
condition.
When to replace belts
To check belts, remove bottom
plate as shown below. Replace
either belt if it is stretched, cut or
broken.
Which belts to buy
To assure effective operation,
use only genuine HOOVER belts
with your cleaner. When pur-
chasing new belts, ask for these
part numbers: Flat Belt- Hoover
part no. 38528-517; V-Belt -
Hoover part No. 38528-523.
How to replace belts
Disconnect cleaner from electri-
cal outlet.
1. Set agitator drive control on
"CARPET" and place handle in
lowest position.
2. Turn cleaner over and remove
the three bottom plate screws.
Lift off bottom plate. Refer to the
following instructions for the belt
you are replacing.
V-BELT
3. Lift up end of agitator and
remove old V-belt from agitator
and idler pulley.
4. Place new belt on outer end of
idler pulley and into belt groove
on agitator. Proceed to step 8.
15
FLAT
PULLEY-_
V-BELT