Hoover innovation U4231 Owner's Manual page 17

FLAT BELT
3. Remove agitator and V-belt as
directed in replacing V-belt.
4.
Work old flat belt off motor
and idler pulleys.
5. Slide new flat belt as far as
possible onto motor pulley.
6. Stretch belt and roll outer
surface onto idler pulley.
Be sure lower edges of belt are
positioned between sides of wire
guide.
7. Replace V-belt on outer end of
idler pulley and into belt groove
on agitator.
SQUARE
PROJECTION
8. Reposition agitator by sliding
square projection on belt end of
agitator into square slot on side
of nozzle. Then slide round pro-
jection on other end of agitator
into round slot.
16