Hoover F5835-900 Service Instructions Manual page 8

The motorcoverassemblyconsistsof the recovery
tank latchesanddistributor.
_M
To remove distributor.
1. Push outward on distributor stem while pulling out
and down on 'T' boss. Distributor will snap out of
housing. (Fig. 22)
N. Handle release, switch lever and switch
Lower the handle to lowest position.
1. Remove trunnions - two screws in each.
(Fig. 23)
2. Unclip cord from cord clip in rear of handle.
MOUNTING
SCREWS
TRUNNION
1 I
I
Fig. 23
3. Lift lower handle out of position.
Handle release lever
The RH trunnion traps the handle release lever. Slide
lever inward then up to remove. (Fig. 24)
\ ',
\
Fig. 24
Switch / switch pedal
1. The LH trunnion houses the on/off switch and
traps the switch lever. (Fig. 25)
LH
TRUNNION
ON/OFF
SWITCH
SWITCH
LEVER
Fig. 25
2. Disconnect leads and snap switch out of trunnion.
3. The switch pedal can be removed once
the trunnion is lifted.
0. Cord
With motor cover removed cord can be accessed