Advertisement
1. General
The steam vac is a self contained
domestic
extractor
designed
for deep cleaning
of carpet and rugs.
Initial models incorporate
six and seven amp motors.
Top of the line models include
a tool kit which allows
the unit to be used for stair or upholstery
cleaning.
This instruction
deals with the top of the line models.
Instructions
that pertain
only to low end models will be
noted,
II. Operation
The units are controlled
by the on/off pedal located on
the LH side,
ON/OFF
PEDAL
Solution
is gravity fed to the floor from the solution
tank through
the reservoir
assembly
to the distributor,
The reservoir
assembly
is opened
by actuating
the
trigger in the handle.
Suction
is directed
to the floor through
the clear
nozzle and up into the recovery
tank where the air
and water are separated.
A float prevents
the
recovery
tank from being overfitled.
The turbine (air) pump operates
on the suction
from
the motor.
Suction is directed to the pump through
the pump duct, and is completed
when the door on
the hood is opened.
The Pump gets a constant flow of solution from the
solution
tank through
the reservoir
assembly.
On
models without
the pump, the pump tap on the
reservoir
is plugged.
The recovery
tank can be unlatched
and carried to
empty.
The toot set can be used by removing
the tank duct
and replacing
with the hose assembly.
Open tool
door and connect
hose.
This will direct solution
and
suction to the hose grip.
III. Disassembly
A.
Solution
tank
To remove,
unlatch
and pull tank assembly
out of position.
(Fig. 1)
HANDLE
Fig. 1
Advertisement
