Hoover F5835-900 Service Instructions Manual page 5

Fig. 6
The. handle i.q r_.nlaep.d a._ an a._._.mhlv
The handle is replaced as an assembly.
If the upper handle rod becomes dislodged during
disassembly, reposition it with the large fin towards
the front of the handle. (Fig. 7)
Fig. 7
_ LARGE FIN
TOWARDS
FRONT
Slide it up into the handle until it snaps into position.
E. Recovery tank
1. Release handle to lowest position (RH side pedal)
2. Pivot two latches outward (Fig. 8) and lift off tank.
LATCH
Fig. 8
3. Remove lid assembly. (Fig. 9)
The lid is carried in service as an assembly that
includes the lid, float retainer, float and filter.
F. Recovery tank duct
1. Slide out of position. (Fig. 10)
Fig.
FRONT
PANEL
G. Hood assembly
1. Remove screw - located below recovery tank at
top rear of hood. (Fig. 11)
Fig. 11