Advertisement
2. Carefully
pry inward on rear panels of hood to
release
snaps.
(Fig. 12)
Fig. 12
1. Lift hood until it clears latches and push forward to
remove.
H. Nozzle
front plate / seal
The nozzle front plate is stocked
as a part of the hood
assembly.
It is not recommended
the front plate be removed.
This could damage
or misposition
the seal which is
critical to the machine's
performance.
I. Door
assembly
1. Open door and pry outward
on either side
to release
one pin and remove.
(Fig. 14)
The door is replaced
as an assembly
(door, seal and
speed nut).
J. Door spring
1. Positioned
on hood boss per illustration
in
Fig. 15.
Fig. 15
To reassemble
hood.
1. Position two locating
tabs in front corners
into
mating boss on base and pivot hood down into
position
until the sides of the hoods snap into
retaining
bosses.
2. Replace screw and tighten.
K. Pump assembly
(where
applicable)
1. Remove
screw. (Fig. 16)
,
3.
Fig. 16
Disconnect
tubing coming from handle assembly.
Release snap and lift pump out. (Fig. 17)
Advertisement
