Replaceable
components
of the tank assembly
include
the cap assembly,
cap gasket and poppet
valve.
B Cap assembly
1. Twist off to remove.
(Fig. 2)
Fig. 2
Fig. 2
2. Slide gasket
off to replace.
(Rib on gasket faces
toward cap.)
C.
Poppet
valve
1.
Insert screwdriver
through
tank opening
and push valve until it snaps out of seat. (Fig. 3)
Fig. 3
Fig. 3
2. Work valve stem out of tank from underneath.
3. The spring, brass washer and valve seat will stay
trapped
in the valve seat.
Remove
through
tank
opening.
Note positioning
in Fig. 3A.
SPRING-._/_
WASHERT_
_'
VALVE SEAL'_t_
Fig. 3A
VALVE STEM "'_
._
The cupped
end of the valve seal faces downward
upon reassembly.
To reassemble
valve:
1. Slide valve assembly
into valve seat through
opening
in bottom of tank. (Fig. 4) Use a small
amount of soap on seal to case assembly.
2. With small screwdriver,
work rubber washer
into
With
£mnll
£nr#wttrivnr
wnrk
rllhh#r
housing.
(Fig. 5)
3.
Continue
to slide shaft in until it stops.
Fig. 5
4.
Valve should spring open and closed when
fully seated.
D.
Upper
handle
assembly
1.
Remove
two bolts and slide handle off. (Fig. 6)